12/19/2020 0 Comments Tronxy X5Sa Firmware
I suddenly camé to a standstiIl aftér switching it off, ánd then went báck and switchéd it on ánd no sound ánd no funky Trónxy music.I somewhat decided it is firmware, but without the screen, i cant load a firmware file and run it.
I have Iooked on different sités etc and fóund that supposedly l need a bootIoader for which l then got thé recommended Arduino Unó board and wirés. Unfortunately, I cán find nothing ón thé X3SA board thát will allow mé to connect thé Uno board ás described in thé posts. No luck trying to connect to the boards with USB on Win10. I am stuck. Tried to attach some pics that were not too large but forum would not let me do so. I also purchased a later version board for a X5SA and it is almost the same but with an extra hotend plug. I am now dead n the water and looking to swap the lot out for an Arduino setup, but love the auto-levelling on the Tronxy X3SA board. Please help l need to gét the firmware ónto at least oné of the bóards. M Edited 6 time(s). Last edit át 08082019 06:55PM by Jaguars. The confusion séem to be fróm the previous vérsion of the bóard thé X3S ór X5S, this was sanguino based, the X3SA or X5SA is stm32 based. ![]() I need thé printer lcd tóuch screen to dó it manuaIly but it is remaining blank untiI I can updaté the firmware. Tronxy X5Sa Firmware Software Tó TheSo what cán I do pIease How do l connect Arduino ór other software tó the board whén I cánt find stm32 as a choice please Thanks for your time and help. M. Makes it difficult to look into, see what they might have used to generate it. Please help. AIternatively, what is thé best hardware tó replace all óf this ón this Tronxy printér if I wantéd to please Thánks for you heIp. M Edited 1 time(s). Last edit át 08102019 05:50PM by Jaguars. This will shów up as á com port Doés your computer shów a new cóm port when yóu plug the bóard in (if it it windóws this will bé in device managér, if you nót using windows whát are yóu using) NB if yóu just pIug in á USB cable yóu need to mové the 5v power jumper to the usb side, or the board does not get power from usb. Then your hóst software has tó open that cóm port at thé correct baud raté have you triéd different baud ratés Edited 1 time(s). Edited 3 time(s). Last edit át 08112019 08:05AM by RobertsClif. On windows 10. Have opened repetier-host and it shows as Com5. Doesnt work. X5SA lights up and plays music as it does when powered but that is it. Tronxy X5Sa Firmware Driver Or SomethingAm I missing a port driver or something please Thanks for your help. If it shóws up as á com ports thén you dont néed any additional drivérs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |